Uni-Solar PVL-128 Flexible Solar Laminate 128W 24V Carton 30 Panels 3840W For Sale

Uni-Solar PVL-128 Flexible Solar Laminate 128W 24V Carton 30 Panels 3840W

Uni-Solar PVL-128 Flexible Solar Laminate 128W 24V Carton 30 Panels 3840W

This listing is for a full factory carton of 30 Uni-Solar PVL-128B flexible amorphous thin-film solar laminates, totaling 3,840 watts of solar capacity. The PVL-128 is a photovoltaic laminate made by United Solar Ovonic (Uni-Solar) designed to bond directly to metal and membrane roofing surfaces without penetrations or mechanical fasteners. Each panel uses triple-junction amorphous silicon cells encapsulated in a durable ETFE polymer film with a self-adhesive ethylene propylene copolymer backing. This carton includes MC4 cables and a junction box for DIY installations.

Specifications & What\'s Included

• Model: Uni-Solar PVL-128B (PVL-128 with bottom-facing 4\" wire configuration)


• Quantity: 30 panels per carton


• Total carton power: 3,840W


• Maximum Power (Pmax) per panel: 128 Wp


• Production Pmax tolerance: ±5%


• Nominal operating voltage: 24V


• Max Power Voltage (Vmpp): 33.0V


• Max Power Current (Impp): 3.88A


• Open Circuit Voltage (Voc): 47.6V


• Short Circuit Current (Isc): 4.8A


• Maximum series fuse rating: 8A


• NOCT Max Power: 100W @ Vmp 30.8V / Imp 3.24A


• NOCT Voc: 43.5V; NOCT temperature: 46°C


• Panel dimensions: 216\" L × 15.5\" W × 0.2\" thick (5,486 × 394 × 4 mm)


• Panel weight: 16 lbs (7.7 kg)


• Cell type: Triple-junction amorphous silicon, 356 mm × 239 mm connected in series


• Encapsulation: Durable ETFE high light-transmissive polymer


• Adhesive: Ethylene propylene copolymer adhesive-sealant with microbial inhibitor


• Output cables: 4 mm² (12 AWG), 560 mm (22\") length; bare bottom-facing 4\" wire leads (red = positive, black = negative)


• Bypass diodes: Connected across every solar cell — shading or soiling of one cell affects only that cell\'s output (typically less than 4.5% total loss)


• Maximum system voltage: 600 VDC (UL)


• Wind/hurricane rating: Category 3, 130 MPH uplift resistant; no mounting hardware required


• Certifications: UL 1703 listed to 600 VDC, IEC 61646 v1 certified, IEC 61730 and TUV certification pending at time of data sheet publication


• Installation temperature range: 10°C to 40°C (50°F to 100°F)


• Maximum operating temperature: 85°C (185°F)


• Roof slope range: Minimum 5/8:12 (3°), maximum 21:12 (60°)


• Approved substrates: PVDF coated (Galvalume® or Zincalume®) steel metal roofing pan with flat surface; EPDM and TPO membranes from approved manufacturers; minimum 406 mm (16\") width


• Data sheet part number: AA5-3851-02


• Included: 30 PVL-128B solar laminates, MC4 cables, junction box for DIY installations

Applications

The Uni-Solar PVL-128 is designed specifically for commercial and residential metal roofing and membrane roofing systems where traditional glass-framed crystalline panels are impractical. Because the laminate bonds directly to the roof surface with its self-adhesive backing, installations avoid roof penetrations entirely — a significant advantage on flat or low-slope commercial roofs where leak risk is a primary concern. The flexible, glass-free construction makes these panels roughly one-fifth the weight of equivalent crystalline modules, which matters on load-limited roof structures. Amorphous thin-film technology gives the PVL series a performance advantage in low-light and high-temperature conditions compared to crystalline silicon panels: the triple-junction cell stack captures a broader portion of the solar spectrum, and the negative temperature coefficient means output degrades less on hot roof surfaces. These panels are commonly used on standing-seam metal roofs, TPO and EPDM membrane commercial roofs, and in off-grid systems where a low-profile, non-penetrating installation is required. The 24V nominal voltage makes them compatible with standard 24V battery banks and common grid-tie and off-grid inverters. Uni-Solar (United Solar Ovonic) produced the PVL series at their Michigan facility; production of new panels has ceased, making existing new-in-carton stock increasingly sought after for roof replacement projects and system expansions that used the original laminate design.

Condition: New
This Uni-Solar PVL-128 flexible solar laminate carton is brand new and unused. The carton contains 30 panels, each individually separated with cardboard interleaving as seen in the photos. MC4 cables and a junction box for DIY installations are included with every panel. Each panel has bottom-facing 4-inch bare wire leads (red positive, black negative) for connections made below the panel surface. Shipping is via freight to your nearest terminal for customer pickup — please contact us to confirm freight details before ordering. Please view our photo set and contact us if you have any questions. Visit Our Store

Shop industrial, solar, scientific, vintage computing, electronic test, audio-visual, office equipment, and manuals in our store. Start shopping »

Follow Our store

Want first pick on new arrivals? Tap Save Seller at the top of any page — alerts you the moment we list something new.

Fast Shipping

We ship via most standard carriers. Local pick-up available at our Ventura, CA warehouse.

About Us

Questions? Contact us anytime. Learn more about us »

Best Offers

Want to make an OFFER but don\'t see a MAKE OFFER button? Use the Contact Seller button at the top of this listing.

30-Day Guarantee

100% satisfaction guaranteed. Any issue, just reach out — we\'ll make it right.

Thank you for shopping with us.