When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Re-Live BT Internal Bluetooth Mod Kit
✨ Key Features⚡ Plug & Play Wiring
Power cable comes pre-assembled and ready to connect. No soldering or terminal crimping needed for the power connection or the touch sensor.
📶 Built-in Bluetooth
Powered by BlueRetro open-source technology. Low latency, wide controller compatibility, up to 4 players.
💡 Smart Power Control
Turn ON/OFF remotely using a button combination on your controller, or use the hidden touch sensor on the front panel.
🔊 Acoustic Confirmation
🌞 Original Aesthetics
Custom purple PCB with a perfect internal fit. Original ports and stock exterior remain completely intact.
🔗 SD2PSX_IN Ready
Complete your build
SD2PSX_IN — Infinite Virtual Memory Cards
Our custom-designed internal memory card module for PS1 & PS2. Store thousands of save files on a single MicroSD card — completely hidden inside the console, with only a small OLED display slot visible from outside. Factory-clean finish, infinite capacity.
MicroSD storageOLED displayPS1 & PS2100% internalBlack or White
🎮 Controller CompatibilityPS5 DualSensePS4 DualShock 4PS3Xbox Series X|SXbox One WirelessSwitch ProJoy-Cons8BitDoWiiU Pro+ more via BlueRetro📋 Compatibility & Technical Notes
Compatible models: PS1 FAT SCPH-550x, 700x, 750x, and 900x series.
NOT compatible: SCPH-100x to SCPH-500x series are NOT supported.
Installation: Basic soldering skills required to mount components onto the new PCB. Power connection and touch sensor are plug-in only — no soldering needed for those steps.
Wired controller testing note: Due to voltage threshold differences across original PS1 controller revisions, some wired PS1 controllers may not be detected by the module. A wired PS2 controller (DualShock 2) is fully compatible and recommended for initial testing.
📦 What\'s in the Box
- 3D Printed Mount — Pre-installed touch sensor included.
- Internal Buzzer — For acoustic power response.
- Pre-assembled Power Cable — Ready to plug in, no terminal crimping needed.
⚠️ Important — Please Read
- The SD2PSX_IN module is NOT included and must be purchased separately.
🛡️ Warranty & Support
- Full technical support provided. Contact us anytime with installation questions.
- Returns accepted only if the item is in its original, unused and unsoldered condition. Every kit is individually tested before shipping.
Based on BlueRetro by DarthCloud (open source) · Made by TecnoBit Videojuegos · Tampa, FL
