When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
BOW STAND FOR MATHEWS BOWS
PLEASE CHECK PICTURES AND MAKE SURE THIS IS FOR YOUR MODEL.
I now have a version forMATHEWS EXO Engage Limb Legs Earth Lift Lift X Lift RS Lift XD styles HERE.
Carbon Fiber texture.
Also available in gray here
All limb legs sold are tested before being shipped out. With that being said, I will not be offering refunds for improper use.
These limb legs come with all the hardware and are assembled.
These limb legs are lighter and cheaper than the metal limb legs. No one I have made them for has had issues with them breaking. I print them at 72% infill, which is the highest percentage I have seen. Installing the legs properly is very important because if done incorrectly it could break the limb legs. To properly install to the bow, place the middle piece under the limb legs and make sure it is snug before trying to clip the legs around the bow. If there is a lot of pressure on the limb legs when trying to clip them in it is not pushed in enough and it will need to be pushed farther before it can be properly clamped.These bows use the Mathews wide-limb platform that Engage Limb Legs are made 32*This is a 3d print replica, not a Mathews official product.
As with all 3d prints there are some visible layer lines and small cosmetic defects. Structurally, they are strong and stable.If there are ANY problems with your order, please simply REACH out to me on before you leave any response, using the Contact Seller option and I will make it right!
*Note that there may be imperfections in the look of the limb legs, mainly the bottom(see pics), but that is only a cosmetic defect. Structurally, they are strong and have no issues. My quality control is heavy, I aim to only ship out a reliable, well-built product.
