When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
********NOTE:*************** Before going any further.....This item requires a basic skill set of wiring, electronics and the abilityto follow basic diagrams (included) If you don\'t think you posses these skills then consider having a professional install this for you or just plain pass on this item. We are getting too many \"wanna-be\" mechanics with this item that do not qualifywith the above needs. I bring this up to save both of us time and aggravation. Thank You
Check out this Quality V-Twin Harley style, replacement throttle by wire twist grip sensor (with internally routed switch wires). This allows installation of stock or accessory handlebars.Throttle by wire twist grip sensor allows installation of stock or accessory handlebars.Hardwired like OEM CVO version from the sensor to the main connection on the harness. Terminals are pre-installed.INSTALLATION INSTRUCTIONSIncludes 6 position connector for installation after the harness is routed through handlebars. Be sure grip is mated snugly against the gear drive to prevent damage. After installing new twist grip sensor, set the right handlebar switch to run. Turn ignition switch on, you will hear the fuel pump cycle on and off. Wait 30 seconds and turn ignition switch off. Wait for turn signals to flash for 30 seconds. Repeat this process 2 more times. This will reset the throttle body and make it in sync with new twist grip sensor.
More InformationOEM Harley Part Number: 32310-08AUOM 1 - EAManufacturer V-TwinOrigin Imported2 Long wire harness\' are 34\" in length short harness is 24\" in length
Replacement Items 32-1211 - T-Stud RetainerNOTE: ONLY fits the following motorcycles...VERIFY your needs before you purchase !FITS Harley-Davidson FLT 2008-2013 models WITH internally routed switch wires Only !
