Automatic Boat Latch - Sport Model - Short Handle - Ramp N Clamp - Boat2Trailer For Sale

Automatic Boat Latch by Ramp N Clamp and Boat2Trailer. This Automatic Boat latch allows a person to load a boat and launch a boat in seconds instead of minutes. This automatic boat latch replaces the boat trailer roller on your boat trailer. When you drive your boat up the trailer, the automatic boat latch will grab the eye on your boat and lock the boat to the trailer once it comes into contact with the clamp. You may then pull your boat and trailer out of the water and into the dry area to hook up your strap and chain for travel. Below is a detailed description of the Sport Model Short handle automatic boat latch.

• This is the SPORT MODEL - Short Handle - Comes With Both Manual and Automatic Reset Handles - The sport model is for fiberglass boats and also works with aluminum boats that have a directly mounted standard U bolt bow eye that does NOT have a thick mounting plate about it. This model is common and works on 95 percent of boats out there. This specific model DOES NOT Work on aluminum LUND, alumunum Alumacraft, Aluminum Ranger or Tracker boats. Please refer to our other models for these setups.
• Stainless Steel NON Corrosive - Upgraded Stoltz Polyurethane Protector - Comes with a small Roller on the front to prevent the bow tip from catching when launching - Built in poly washer on the mounting plate for a smooth pivoting rotation - Clamp travels past the polyurethane to prevent steel on steel wear to your bow eye when latching and traveling - Low profile design to prevent boat and trailer displacement after install
• Installation of the Boat2Trailer automatic boat latch is very simple. This boat latch is designed to be a bow roller replacement, therefore it is a one bolt installation. You can simply remove your bow roller from your boat trailer and install our Ramp N Clamp Boat2Trailer automatic boat latch in its place. The installation takes roughly 10 minutes. Be sure to use roughly 18 - 20 ft lbs pressure on the insall bolt (snug). This way your latch can still pivot when needed at steeper landings.
• MADE IN USA - Our Boat2Trailer Latch by Ramp N Clamp is manufactured here in the U.S.A. The automatic boat latch by Ramp N Clamp has been collaboratively engineered at Skeeter, Ranger and Mastercraft boats and in production in the United States since 2012.
• What it does - The automatic boat latch allows you to load a boat by your self in seconds. You simply drive your boat up the trailer. Once the eye of the boat comes in contact with the clamp device, it will lock onto the eye and lock your boat to the trailer. You then exit the boat and pull to the dry waters edge to hookup your safety chain and strap for travel. It\'s that easy. Boat2Trailer dot com has many helpful videos as well.