When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Product Description
Features:
Built to strict quality control standards 100% factory tested.
Consistent starting power with a high quality solenoid that properly engages the starter drive with the flywheel in your vehicle every time the ignition key is turned.
High standards for components like wiring, brushes, insulation, bearings and coatings for consistent performance in all environmental conditions.
High performance machining of the starter casing for ease of installation and solid joining of the starter housing and your vehicle\'s mounting on Rating:1.3KW
Starter Type:PMGR
Part Numbers:
Chrysler: 04801852AB, 4801852AB, RL801852AB
Denso: 428000-7210
Lucas: LRS04099
Lester: 19185
PIC: 190-6374
Arrowhead: SND0787
BBB Ind: 19185
Bosch Remanufactured: SR6487X
Carquest: 19185S
Remy Remanufactured: 25013
J & N Automotive: 410-52417
NAPA: 244-6410
Wilson: 91-29-5800
Dixie Electric: S-80515
Fitment:
Chrysler 300 2011-2016 V6 3.6L
Dodge Challenger 2011-2016 V6 3.6L
Dodge Charger 2011-2016 V6 3.6L
Dodge Durango 2011-2015 V6 3.6L
Jeep Grand Cherokee 2013-2015 V6 3.6L
Ram 1500 2013-2014 V6 3.6L RWD; Exc. Stop/Start Feature
Package include:
1 x to Install a Car Starter?
1. Disconnect the battery.
2. Jack up the vehicle if need be.
3. Locate the starter.
4. Disconnect the wiring to the solenoid.
5. Remove the starter retaining bolts then the starter.
6. Compare the new starter to the old one. Slide the starter into place.
7. Insert the starter retainer bolts.
8. Connect the wiring to the starter solenoid.
9. Reconnect the battery.
10. Listen to the vehicle as you attempt to start it.
11. Ensure the battery terminals are clean and secure.Charge your vehicle’s battery.
12. Check to see the starter solenoid is bad.
Note:
Starter Fault Check:
The starter often has failures and phenomena that cannot rotate or rotate slowly. In this case, check the following aspects:
1. The battery has no electricity or the electricity is weak, so the starter cannot rotate or rotate slowly.
2. The starter thread is loose or off, and the switch or adsorption switch fails.
3. The brush is worn out or the brush surface is not correct, and the spring is weak, resulting in poor contact of the rectifier.
4. Excitation coil or armature coil is short-circuited or disconnected.
5. The rectifier is fouled and the mica sheet is protruding, causing poor contact between the brush and the rectifier.
