For 2 Dogs Safe Electric Dog Fence Pet Containment System Shock Collars For Sale

Electric Dog Fence System Pet Tone Shock Boundary Containment Water Resistant Collar Receiver For Small Medium Large DogOur electric dog fence system is a reliable, cost-efficient pet containment system. A buried wire transmits a harmless radio signal.

When your dog approaches the boundary, the signal causes the dog’s collar receiver to deliver a warning beep first.

.

Note:

*Only use it for dog, not any other animals.

*Let your dog adapt to the collar before you start training. You should allow your dog to accept the collar as a part of her life.

*When the collar in your dog, do not set the program.

*Keep away from children can touch the place.

* Please read all instructions before using this product.

Keep safe in limited space.

Results of System Test Procedures:

1. If there is no green POWER light on the wall transmitter with the test loop wire in place, the wall transmitter is malfunctioning.

2. As this unit has a protection function, if some matters or operate fault cause the system halted (no green POWER light), please unplug the power of the transmitter. after ten minutes plug the power again, it will recover to normal work.

3. If the green POWER and OK lights are solid on the wall transmitter, but the collar does not activate on the test loop wire, the collar receiver is not working. Change the battery in the collar receiver and repeat the test.

4. If the red Break light on the transmitter turns on together with beeping sound, the problem is in the yard wire.

Your dog will naturally seek to avoid correction, and is content staying within established boundaries.

If your dog continues closer to the boundary, the system will issue a mild shock. If your dog continues further, the system will issue stronger shocks until your dog returns to within the boundary you have set up

Electric Dog Fence System Materials: ABSRun time: About 10 Days

Adjustable Control Range: Up To 5000 Square Meters/53189Square FT/1.2Acre

Pet Collar Fits Dogs 4lbs+ with Neck Sizes From 7.5in To 17.92in

Bury Wire Cable Length: 300m/984FT

Suggested Wire Bury Depth: More Than 1in Underground

Package Contents

• 1x Indoor Wall-mounted Transmitter
• 2x Adjustable Receiver Collars w/Neck Straps
• 1x Power Adapter w/ Charging Cable
• 1 Coil x Boundary Wire
• 20 x Training Flags
• 2x Test Bulbs;1Bag x Screw
• 2Pairs x Extra Metal Contact Points

It will be better to bury only 1-3inches.

How It Works:

1) Wall-mounted transmitter:Transmitter is the central controller to whole electronic system. Make sure the wire is set to a loop.

2) The receiver collar:Receiver (collar)will make a warning beep firstly and then continuous stimulation if your dog attempts to approach wire boundary.

3) How to install the system

*Design your containment area and calculatethe amount of wire needed.

*Install the wall transmitter.

*Lay out the perimeter wire.

*Connect the perimeter wire to the wall transmitter.

*Verify transmitter is functioning without problem.

*Set up the receiver and then, test the containment system and adjust the field width.

*Install the boundary wire and training flags.

*Fit collars to your dogs and train your dogs.

Use advice: Please do not let your dog use the receiver for a long time. (Recommended no more than 8 hours)

Launch Notes:

1. The rotary switch maintains the maximum output and ensures that the transmitter can work normally.

2. The transmitter does not support 12V voltage, and does not support rain/exposure.

3. Before clipping the wire, remove the end of the wire to leak out the wire core, then clip it on the transmitter, and emit two green lights to prove that it is working.

4. The premise of burying the line must ensure that the line (left of line A) (right of line B) cannot be knotted, otherwise the signal will be affected.

Receiving Notes:

1. The receiver does not support soaking in water.

2. Pay attention to identify the positive and negative poles during installation, and do not install them in reverse.